DFROBOT LITHIUM BATTERY CHARGER

600.00

Category:

Description

INTRODUCTION
If you need to charge LiPo batteries, this simple charger will do just that, and do it fast! The Lithium Battery Charger can charge 3.7V LiPo battery at a rate of 500mA per hour. It is designed to charge single-cell Li-Ion or Li-Polymer batteries. Check the datasheet below to see if it will work with your battery.

The board incorporates a charging circuit, status LED, connector for your battery (JST-type used in the batteries we carry), and a micro-USB connector. Four small mounting holes allows this charger to be easily embedded into a project.

SPECIFICATION
Programmable Charge Current:Up to 1000mA
Constant-Current/Constant-Voltage
Types of battery:Single-cell Li-Ion or Li-Polymer batteries
Interface
Charge from Micro USB
JST-type or terminal connect to battey
With ON/OFF switch,3 status LEDs
Accuracy:1.5% @ Preset 4.2V Charge Voltage
C/10 Charge Termination
Operating Ambient Temperature:-40℃~85℃
Size:3.2×2.7x1cm(1.26″x1.06″x0.39″)

DOCUMENTS
TP4056 datasheet
Schematic